User`s guide

12 XSR User’s Guide
Utilizing the Command Line Interface Chapter 2
Managing the XSR
Figure 1 Sample Configuration Mode Tree
The footnotes below refer to command options cited in the illustration.
1 if-type can be one of the following: Serial, FastEthernet,
GigabitEthernet, BRI, loopback, Multilink, VPN, or Dialer
2 router-parameter can be: RIP or OSPF
3 controller can be one of the following: T1 or E1
4 Some attributes can be set at this level without acquiring other
modes. For example:
access-list access-list-num [deny |
permit] [parameter [parameter…]]
5 Show commands can all be entered at EXEC, Privileged EXEC or
Global modes.
Login
EXEC
enable
Privileged EXEC
configure
Global Configuration
Config-if
Config-Router
Controller
T1/E1
1
2
3
4
Interface if-type num
Router router-parameter
Controller cont-parameter
show commands
show commands
5
5