User`s guide

XSR User’s Guide 375
Appendix A Alarms and Events
Alarms/Events and System Limits
T1 Stop controller failed for slot/card/port. Stop command sent to driver returned an error.
T1 Bind controller failed for slot/card/port. Bind command sent to driver returned an error.
T1 Delete controller object failed for
slot/card/port.
T1E1 controller object delete could not be executed.
T1 Create controller object failed for
slot/card/port.
T1E1 controller object create could not be executed.
SYNC_
DRIV
Recoverable error The device has hard recoverable error.
SYNC_
DRIV
Packets lost > 255 (RX overrun) The number of packets lost due to RX FIFO overrun has
exceeded 255.
PP Out of memory - frame dropped at port <port
number>
When a frame is dropped at the specified port due to out of
memory.
PLATF Need 'snmp-server system-shutdown' for
SNMP reboot
SNMP configuration does not allow reboots.
Frame
Relay
serial a/b:d.e, packet arrived on unconfigured
DLCI nnnn
Data is discarded
ETH1_
DRIV
Recoverable error This alarm indicates that the FastEthernet 2 chip (of the
interface) has experienced a signficant, but recoverable
problem. The interface has already corrected the problem by
resetting itself.
ETH1_
DRIV
Packets lost > 255 (RX overrun) The number of packet that this interface has lost (had to discard)
due to receive FIFO overrun is greater than 255. This alarm will
only occur once.
ETH0_
DRIV
Recoverable error This alarm indicates that the FastEthernet 1 chip (of the
interface) has experienced a signficant, but recoverable
problem. The interface has already corrected the problem by
resetting itself.
ETH0_
DRIV
Packets lost > 255 (RX overrun) The number of packets that this interface has lost (had to
discard) due to receive FIFO overrun is greater than 255. This
alarm will only occur once.
CLI Login failed from address <IP address> due
to timeout
Timeout error during login.
Table 18 Low Severity Alarms/Events (Continued)
Module Message Description