User`s guide

366 XSR User’s Guide
Alarms and Events Appendix A
Alarms/Events and System Limits
ETH1_DRIV Device not found This alarm most likely occurs because of a hardware failure, and
means that the FastEthernet 2 chip cannot be found on the PCI bus
(of the motherboard). When this alarm occurs, the FastEthernet 2
interface is unavailable.
ETH0_DRIV The device is stuck in reset The FastEthernet 1 chip on the motherboard is experiencing severe
problems, in that it cannot come out of reset. The FastEthernet 1
driver/interface cannot be started. This most likely cause of this alarm
is a hardware failure. When this alarm occurs, the FastEthernet
Interface 1 is not available.
ETH0_DRIV The ISR could not be connected This is an internal configuration alarm that occurs because the
interrupt service routine (ISR) cannot be connected to the
FastEthernet 1 interface/driver. This alarm will cause the
FastEthernet 1 interface to be unavailable.
ETH0_DRIV Init string parse failure This is an internal configuration alarm that occurs because the driver
could not parse its initialization string. This alarm will cause the
FastEthernet 1 interface to be unavailable.
ETH0_DRIV OS initialization failure This is an internal configuration alarm that occurs because the
operating system initialization of the driver/interface cannot be
completed. This alarm will cause the FastEthernet 1 interface to be
unavailable.
CLI Failed to create session for web access Failed to start session for web.
CLI Failed to create session for console
access
Failed to start session for web.
CLI Failed to create session for telnet
access
Failed to start session for console.
CLI Failed to create session for telnet
access
Failed to start session for Telnet.
CLI Failed to enable Telnet server Cannot start Telnet server because socket open failed.
CLI Failed to enable Telnet server Cannot start Telnet server because socket bind failed.
CLI Failed to enable Telnet server Cannot start Telnet server because socket listen failed.
CLI Failed to enable Telnet server Failed to enable Telnet server.
CLI CLI Config mode released by user
<username>
When a user exits Configuration mode.
Table 16 High Severity Alarms/Events (Continued)
Module Message Description