User`s guide
XSR User’s Guide 365
Appendix A Alarms and Events
Alarms/Events and System Limits
Frame Relay Serial a/b:d.e, station DOWN, DLCI
nnnn
The network reports station up.
Frame Relay Serial a/b:d cannot establish LMI, port
is down
The network has not been responding for 5 minutes - check
connection.
Frame Relay Serial a/b:d LMI - port DOWN The LMI is reporting the port is Down.
Frame Relay Serial a/b:d LMI - port UP The network is reporting the port is Up.
Frame Relay Serial a/b:d.e Config Error Aggregate
CIR nnnn greater than measured speed
nnn - CIR Assist is DISABLED
Total configured CIR exceeds speed of link - cannot guarantee CIR
and assist will not be operational.
ETH1_DRIV The device is stuck in reset The FastEthernet 2 chip on the motherboard is experiencing severe
problems, in that it cannot come out of reset. The FastEthernet 2
driver/interface cannot be started. This most likely cause of this alarm
is a hardware failure. When this alarm occurs, the FastEthernet
Interface 2 is not available.
ETH1_DRIV The device TX/RX is stuck in reset The FastEthernet 2 chip on the motherboard is experiencing severe
problems, in that either the transmitter or receiver cannot come out of
reset. The FastEthernet 2 driver/interface cannot be started. This
most likely cause of this alarm is a hardware failure. When this alarm
occurs, the FastEthernet Interface 2 is not available.
ETH1_DRIV The ISR could not be connected This is an internal configuration alarm that occurs because the
interrupt service routine (ISR) cannot be connected to the
FastEthernet 2 interface/driver. This alarm will cause the
FastEthernet 2 interface to be unavailable.
ETH1_DRIV Init string parse failure This is an internal configuration alarm that occurs because the driver
could not parse its initialization string. This alarm will cause the
FastEthernet 2 interface to be unavailable.
ETH1_DRIV Unrecoverable error The FastEthernet 2 chip on the motherboard is experiencing severe
problems, in that it has a catastrophic failure. This most likely cause
of this alarm is a hardware failure. When this alarm occurs, the
FastEthernet 2 interface is not available.
ETH1_DRIV OS initialization failure This is an internal configuration alarm that occurs because the
operating system initialization of the driver/interface cannot be
completed. This alarm will cause the FastEthernet 2 interface to be
unavailable.
Table 16 High Severity Alarms/Events (Continued)
Module Message Description