User`s guide

XSR User’s Guide iii
A plug and jack used to connect the XSR to the premises wiring and telephone network must comply with the
applicable FCC Part 68 rules and requirements adopted by ACTA. Refer to the following table and installation
instructions for details.
Codes applicable to this XSR:
If the XSR harms the telephone network, the telephone company will notify you in advance that it may need to
temporarily discontinue service. But if advance notice is not practical, the telephone company will notify you as soon
as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the
operation of the XSR. If this happens, the telephone company will provide advance notice for you to make necessary
modifications and maintain uninterrupted service.
If you experience trouble with the XSR, for repair or warranty information, please contact Enterasys Networks, Inc., at
978 684-1000. If the XSR is causing harm to the telephone network, the telephone company may request that you
disconnect the XSR until the problem is solved. The XSR is not intended to be repaired by the customer.
Independent Communications Authority of South Africa
The XSR complies with the terms of the provisions of section 54(1) of the Telecommunications Act (Act 103 of 1996)
and the Telecommunications Regulation prescribed under the Post Office Act (Act 44 of 1958).
Product Product Identifier
NIM-T1/E1-xx, NIM-CT1E1/PRI-xx US: 5N5DENANET1
NIM-BRI-U-xx US: 5N5DENANEBU
Product Jack Used
NIM-T1/E1-xx, NIM-CT1E1/PRI-xx RJ48C
NIM-BRI-U-xx RJ49C
Product Facilities Interface Code (FIC) Service Order Code (SOC)
NIM-T1/E1-xx, NIM-CT1E1/PRI-xx 04DU9.BN, 04DU9.DN,
04DU9.1KN, 04DU9.1SN
6.0N
NIM-BRI-U-xx 02IS5 6.0N
APPROVED
SS/366.01
APPROVED
TE-2002/190
APPROVED
TE-2002/195