User`s guide

XSR User’s Guide 185
Chapter 8 Backup Configuration
Configuring Dialer Services
XSR(config-if<D1>)#ppp multilink
XSR(config-if<D1>)#multilink min-links 2
The following command configures Serial sub-interface 2/0:0:
XSR(config)#interface serial 2/0:0
XSR(config-if<S2/0:0>)#no shutdown
XSR(config-if<S2/0:0>)#backup interface dialer1
XSR(config-if<S2/0:0>)#encapsulation ppp
XSR(config-if<S2/0:0>)#ip address 30.30.30.1 255.255.255.0
Node C (Called Node) Configuration
The following commands configure two channel groups with three total
timeslots on T1 sub-interface 0/2:0:
XSR(config)#controller t1 0/2/0
XSR(config-controller<T1-0/2:0>)#channel-group 1 timeslots 2
XSR(config-controller<T1-0/2:0>)#channel-group 0 timeslots 1
XSR(config-controller<T1-0/2:0>)#no shutdown
The following commands add a dialer pool member and set the Central Office
switch type on BRI port 1/0:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3
XSR(config-if<BRI-1/0>)#dialer pool-member 28
XSR(config-if<BRI-1/0>)#no shutdown
The following commands add a dialer pool, enable MLPPP, and map BRI
interface 1/0 to Dialer interface 1:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#no shutdown
XSR(config-if<D1>)#dialer pool 28
XSR(config-if<D1>)#encapsulation ppp
XSR(config-if<D1>)#ip address 10.10.10.3 255.255.255.0
XSR(config-if<D1>)#ppp multilink
The following commands configure Serial sub-interface 2/0:0:
XSR(config)#interface serial 2/0:0
XSR(config-if<S2/0:0>)#no shutdown
XSR(config-if<S2/0:0>)#encapsulation ppp
XSR(config-if<S2/0:0>)#ip address 30.30.30.3 255.255.255.0