User`s guide

180 XSR User’s Guide
Switched PPP Multilink Configuration Chapter 8
Configuring Dialer Services
XSR(config-if<D1>)#ppp multilink
XSR(config-if<D1>)#dialer-group 7
XSR(config-if<D1>)#multilink load-threshold 3
XSR(config-if<D1>)#dialer idle-timeout 20
The following command defines interesting packets for the dial out trigger by
configuring ACL 106 to pass all Type 8 source and destination ICMP packets
up to 20 idle seconds:
XSR(config)#access-list 106 permit icmp any any 8
The following command maps ACL 106 to dialer group 7:
XSR(config)#dialer-list 7 protocol ip list 106
Node C (Called Node) Configuration
The following commands add a dialer pool member and set the Central Office
switch type on BRI port 1/0:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3
XSR(config-if<BRI-1/0>)#dialer pool-member 2
XSR(config-if<BRI-1/0>)#no shutdown
The following commands add a dialer pool, enable MLPPP, and map BRI
interface 1/0 to Dialer interface 1. The
dialer called command maps
incoming Node A calls to its 2500 number:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#no shutdown
XSR(config-if<D1>)#dialer pool 2
XSR(config-if<D1>)#encapsulation ppp
XSR(config-if<D1>)#dialer called 2500
XSR(config-if<D1>)#ip address 10.10.10.3 255.255.255.0
XSR(config-if<D1>)#ppp multilink