User`s guide

176 XSR User’s Guide

Configuring DoD/BoD Chapter 8

Configuring Dialer Services

XSR(config-if<D1>)#ip address 172.22.85.1

XSR(config-if<D1>)#ppp multilink

XSR(config-if<D1>)#dialer pool 1

XSR(config-if<D1>)#dialer idle-timeout 20

XSR(config-if<D1>)#dialer map ip 172.22.85.2 47410

XSR(config-if<D1>)#dialer map ip 172.22.85.3 425688

XSR(config-if<D1>)#dialer map ip 172.22.85.4 987762

XSR(config-if<D1>)#no shutdown

XSR(config-if<D1>)#dialer-group 1

The following commands add a pool member and configure the primary-ni

switch on T1 interface 2/3:

XSR(config)#controller t1 2/3

XSR(config-controller<T1-2/3>)#switch-type primary-ni

XSR(config-controller<T1-2/3>)#dialer pool-member 1

XSR(config-controller<T1-2/3>)#no shutdown

The following command maps ACL 101 to dialer group 1:

XSR(config)#dialer-list 1 protocol ip list 101

The following command defines interesting packets for the dial out trigger by

configuring ACL 101 to pass all Type 8 source and destination ICMP packets

up to 20 idle seconds:

XSR(config)#access-list 101 permit icmp any any 8

Dial-in Router Example

The following commands add a dialer pool and configure PPP Multilink on

XSR-Andover’s Dialer interface 1:

XSR(config)#interface dialer 1

XSR(config-if<D1>)#encapsulation ppp