User`s guide

XSR User’s Guide 167
Chapter 8 Configuring DoD/BoD
Configuring Dialer Services
The following command maps ACL 105 to dialer group 7:
XSR(config)#dialer-list 7 protocol ip list 105
PPP Point-to-Point Configurations
The following sample configuration is a PPP point-to-point topology, as
illustrated in Figure 28.
Figure 28 Point-to-Point Topology
Dial-in Routing for Dial on Demand Example
The following commands configure dialer interface 1 with both PPP
authentication enforced and specifies the PPP authenticated username XSR-
Andover to map incoming calls to map incoming calls on XSR-Toronto:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#encapsulation ppp
XSR(config-if<D1>)#ip address 172.22.85.1
XSR(config-if<D1>)#ppp authentication pap
XSR(config-if<D1>)#dialer pool 1
.
XSR-Andover
Switched line
XSR-Toronto
172.22.85.1
172.22.96.1
172.22.80.4
172.22.85.2