User`s guide

XSR User’s Guide 165
Chapter 8 Configuring DoD/BoD
Configuring Dialer Services
The following commands add a dial pool and map BRI interface 1/0 to Dialer
interface 1. Optionally, you can employ the dialer called method to map
incoming Node A calls to Node B’s phone number and add a second Dialer
interface with similar mappings.
XSR(config)#interface dialer 1
XSR(config-if<D1>)#no shutdown
XSR(config-if<D1>)#dialer pool 22
XSR(config-if<D1>)#encapsulation ppp
! dialer called 2400
XSR(config-if<D1>)#ip address 10.10.10.2 255.255.255.0
! XSR(config)#interface dialer 2
! XSR(config-if<D2>)#no shutdown
! XSR(config-if<D2>)#dialer pool 22
! XSR(config-if<D2>)#encapsulation ppp
! XSR(config-if<D2>)#dialer called 2401
! XSR(config-if<D2>)#ip address 20.20.20.2 255.255.255.0
PPP Multipoint-to-Multipoint Configuration
The following configuration sets both peer nodes to initiate the setup of a
switched link when access list-defined data traffic is sent to the remote peer.
The configuration of the two nodes is symmetrical, that is, both nodes can
make and receive calls.
Node A Configuration
The following commands add a dialer pool member and set the Central Office
switch type on BRI port 1/0:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3
XSR(config-if<BRI-1/0>)#dialer pool-member 25
XSR(config-if<BRI-1/0>)#no shutdown
The following commands define a dial group, add a dial pool, configure
Dialer interface 1 with spoofing enabled on XSR-Andover network, and set
calls out to XSR-Toronto to terminate if the line is idle for 35 seconds:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#no shutdown
XSR(config-if<D1>)#dialer pool 25