User`s guide

164 XSR User’s Guide
Configuring DoD/BoD Chapter 8
Configuring Dialer Services
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3
XSR(config-if<BRI-1/0>)#dialer pool-member 25
XSR(config-if<BRI-1/0>)#no shutdown
XSR(config)#interface dialer 1
XSR(config-if<D1>)#no shutdown
XSR(config-if<D1>)#dialer pool 25
XSR(config-if<D1>)#encapsulation ppp
XSR(config-if<D1>)#dialer idle-timeout 20
XSR(config-if<D1>)#dialer-group 3
XSR(config-if<D1>)#dialer map ip 10.10.10.2 2400
XSR(config-if<D1>)#ip address 10.10.10.1 255.255.255.0
The following optional commands can be entered to add a second, similarly
configured, Dialer interface to the dialer group:
! XSR(config)#interface dialer 2
! XSR(config-if<D2>)#no shutdown
! XSR(config-if<D2>)#dialer pool 25
! XSR(config-if<D2>)#encapsulation ppp
! XSR(config-if<D2>)#dialer idle-timeout 20
! XSR(config-if<D2>)#dialer-group 3
! XSR(config-if<D2>)#dialer map ip 20.20.20.2 2401
! XSR(config-if<D2>)#ip address 20.20.20.1 255.255.255.0
The following command defines interesting packets for the dial out trigger by
configuring access list 101 to pass all Type 8 source and destination ICMP
traffic up to 20 idle seconds:
XSR(config)#access-list 101 permit icmp any any 8
The following command maps ACL 101 to dialer group 3:
XSR(config)#dialer-list 3 protocol ip list 101
Node B (Called Node) Configuration
The following commands add a dialer pool member and set the Central Office
switch type on BRI port 1/0:
XSR(config)#interface bri 1/0
XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3
XSR(config-if<BRI-1/0>)#dialer pool-member 22
XSR(config-if<BRI-1/0>)#no shutdown