User`s guide

156 XSR User’s Guide
Configuring a Dialed Backup Line Chapter 8
Configuring Dialer Services
The CLI commands shown below are those used to configure the example
shown in Figure 25:
Configure interface dialer 1 to use dial pool 5:
XSR(config)#interface dialer1
XSR(config-if<D1>)#encapsulation ppp
XSR(config-if<D1>)#dialer pool 5
XSR(config-if<D1>)#no shutdown
Configure interface dialer 2 to use dial pool 5:
XSR(config)#interface dialer2
XSR(config-if<D2>)#encapsulation ppp
XSR(config-if<D2>)#dialer pool 5
XSR(config-if<D2>)#no shutdown
Configure backup serial port for dial purposes to belong to dial pool 5:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#dialer pool-member 5
XSR(config-if<S1/0>)#no shutdown
Configure primary serial port to use dialer 1 as its backup interface:
XSR(config)#interface serial 1/1
XSR(config-if<S1/1>)#backup interface dialer1
XSR(config-if<S1/1>)#backup delay 110
XSR(config-if<S1/1>)#no shutdown
Configure primary serial port to use dialer 2 as its backup interface:
XSR(config)#interface serial 1/2
XSR(config-if<S1/2>)#backup interface dialer2
XSR(config-if<S1/2>)#backup delay 1 10
XSR(config-if<S1/2>)#no shutdown