User`s guide

XSR User’s Guide 147
Chapter 8 Implementing Dial Services
Configuring Dialer Services
Creating and Configuring the Dialer Interface
1 Enter interface dialer number to create the dialer interface.
The number range is 0 to 255.
2 Enter encapsulation ppp to enable PPP encapsulation.
3 Enter dialer pool number to specify the dialer pool.
The number range is 0 to 255.
4 Enter dialer string <dialstring> class <classname> to specify the
remote destination string to be used.
The string is normally a 10-digit telephone number.
Configuring the Map Class
1 Enter map-class dialer classname to create a map-class identifier.
This value must match the classname value you specified in the
dialer string command.
2 Enter dialer wait-for-carrier-time seconds to set the interval the
local modem waits to answer the call.
Configuring the Physical Interface for the Dialer Interface
1 Enter interface serial card/port to specify the interface.
2 Enter encapsulation ppp to set PPP encapsulation.
3 Enter dialer pool-member number priority <priority> to assign the
interface as a member of the pool that the dialer interface will use.
Priority is an optional value you can set to prioritize this pool-
member in the pool ranging from 0 - 255. The number range is 0 - 255.
Sample Dialer Configuration
The CLI commands listed below are those used to configure dialer interface 0
in Figure 21.
Configure interface dialer 0 with two dial strings and map classes for each:
XSR(config)#interface dialer 0