User`s guide

XSR User’s Guide 117
Chapter 6 Configuring BAP
Configuring PPP
XSR2(config-if<BRI-2/0>)#isdn switch-type basic-ni1
XSR2(config-if<BRI-2/0>)#isdn spid1 0337250001
XSR2(config-if<BRI-2/0>)#isdn spid2 0337250101
XSR2(config-if<BRI-2/0>)#no shutdown
XSR2(config-if<BRI-2/0>)#dialer pool-member 1 priority 0
3 Configure the Dialer 1 interface with a dialer pool:
XSR2(config)#interface Dialer1
XSR2(config-if<D1>)#no shutdown
XSR2(config-if<D1>)#dialer pool 1
XSR2(config-if<D1>)#encapsulation ppp
4 Set up BAP on Dialer 1 by enabling BAP and adding BAP phone numbers
for XSR1 to call.
XSR2(config-if<D1>)#ppp multilink bap
XSR2(config-if<D1>)#ppp bap number default 3101
XSR2(config-if<D1>)#ppp bap number default 3102
XSR2(config-if<D1>)#ppp bap number default 3103
XSR2(config-if<D1>)#ppp bap number default 3104
XSR2(config-if<D1>)#ppp bap number default 3105
XSR2(config-if<D1>)#ip address 99.99.1.1 255.0.0.0
Dual XSRs: BAP Using Call/Callback Request
The following example sets up BAP between two XSRs, with XSR1 configured
to perform Dial on Demand (DoD) and request additional links by sending a
callback request to XSR2, which also is configured with DoD and requests
additional links with call requests to XSR1.
XSR1 Configuration
XSR1(config)#controller e1 2/0
XSR1(config-controller<T1-2/0>)#pri-group
XSR1(config-controller<T1-2/0>)#no shutdown
!
XSR1(config)#interface Dialer1
XSR1(config-if<D1>)#no shutdown
XSR1(config-if<D1>)#dialer pool 1