User`s guide

96 XSR User’s Guide
Configuring Unnumbered IP Serial Interface Example Chapter 5
Configuring IP
XSR(config-if<S2/0:0>)#encapsulate ppp
XSR(config-if<S2/0:0>)#ip unnumbered fastethernet 1
XSR(config)#router rip
XSR(config-router)#network 192.168.1.100
XSR#copy running-config startup-config
Configuring Unnumbered IP Serial Interface Example
The following example configures an X.21-type, serial interface 1/0 as an
unnumbered serial interface. Serial 1/0 is directed to use the IP address of
FastEthernet port 1.
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#ip address 192.168.1.1 255.255.255.0
XSR(config-if<F1>)#no shutdown
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#media-type x21
XSR(config-if<S1/0>)#encapsulation ppp
XSR(config-if<S1/0>)#ip unnumbered fastethernet 1
XSR(config-if<S1/0>)#no shutdown
XSR#copy running-config startup-config
Configuring OSPF Example
The following is a sample configuration of OSPF which adds three networks
to OSPF areas including stub and NSSA areas, sets the retransmit interval on
interface FastEthernet 1 to 9 seconds, specifies the cost of sending traffic on
interface Serial 1/0 to 64, and redistributes static routes into OSPF:
XSR(config)#interface FastEthernet 1
XSR(config-if<F1>)#no shutdown
XSR(config-if<F1>)#ip address 192.168.1.100 255.255.255.0
XSR(config-if<F1>)#ip ospf retransmit-interval 9
XSR(config)#interface FastEthernet 2
XSR(config-if<F2>)#no shutdown
XSR(config-if<F2>)#ip address 156.57.99.3 255.255.255.0
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#no shutdown
XSR(config-if<S1/0>)#media-type V35
XSR(config-if<S1/0>)#encapsulation ppp