User`s guide

16 Aurorean Network Gateway-1100 User’s Guide
Chapter 3
Configuring the ANG-1100 with Aurorean Web Config
Setting Up the VPN
The VPN configuration created on the ANG-1100 completes a link with the
ANG-3000/7000 on the remote end of this connection. If your network
administrator has already set up the ANG-3000/7000 with appropriate User,
Password and Group information, after setting up the VPN you will build the
site-to-site tunnel connection and be up and running on the corporate LAN.
Before you start VPN configuration, be sure that your network administrator
has supplied any IP addresses and masks required
Begin VPN Setup by performing the following steps:
1 Click the VPN Setup menu option.
The VPN Setup window appears as shown in Figure 14.