User`s guide

Aurorean Network Gateway-1100 User’s Guide 7
Chapter 2 Connecting Cables
Installation
Figure 7 Connecting Cables to the ANG-1100 (ANG-1105 shown)
3 Plug an Ethernet cable into the External port as shown in Figure 7.
4 Plug the opposite end of this cable into a DSL or cable modem.
NOTE
If you have a DSL modem, you will need to get an IP address from your
provider and configure it. This condition may also exist for selective cable
customers. Some cable internet providers require that you supply the
MAC address of your computer. Refer to Chapter 3 for directions.
Serial Connection
The ANG-1105 is equipped with one 9-pin DB-9 port for use as a console port.
You can then start a Hyperterminal session or establish a link using another
terminal emulator.
Connecting an ANG-1105
To connect the ANG-1105 serial port, connect one end of a null modem cable
(female-to-female) to the DB-9 port and another to the DB-9 port on your PC.
Cross-over cable for
direct PC connection
P
O
W
E
R
C
O
M
E
X
T
E
R
N
A
L
4
2
3
1
T
R
U
S
T
E
D
R
E
S
E
T
by ANG-1102 or
Straight-through cable for Hub
connection by ANG-1102 or direct
PC connection by ANG-1105
OR
Hub connection
by ANG-1105
Straight-through cable
for connection out to
DSL or cable modem
Connection to
serial port on PC