Specifications

32 VH-2402S2 User Interface VH-2402S2

Viewing the Current Port Configuration

The Port Information screen displays the port type, status, link state, and

flow control in use, as well as the communication speed and duplex mode.

To change any of the port settings, use the Port Configuration menu. The

parameters shown in the following figure and table are for the RJ-45 ports.

Figure 2-22. Port Information

Vertical Horizon Stack Local Management

Port Information : Unit 1 Port 1-12

Port Type Operational Link FlowControl Speed and

InUse Duplex InUse

------------------------------------------------------------------

1 10/100TX YES DOWN -------------- ----------

2 10/100TX YES DOWN -------------- ----------

3 10/100TX YES UP 802.3x 100-FULL

4 10/100TX YES DOWN -------------- ----------

5 10/100TX YES DOWN -------------- ----------

6 10/100TX YES DOWN -------------- ----------

7 10/100TX YES DOWN -------------- ----------

8 10/100TX YES DOWN -------------- ----------

9 10/100TX YES DOWN -------------- ----------

10 10/100TX YES DOWN -------------- ----------

11 10/100TX YES DOWN -------------- ----------

12 10/100TX YES DOWN -------------- ----------

Use <TAB> or arrow keys to move. <Enter> to select.

Parameter Description

Type Shows port type as:

10/100TX : 10Base-T / 100Base-TX

100FX : 100Base-FX

1000SX : 1000Base-SX

1000LX : 1000Base-LX

1000T : 1000Base-T

GBIC : GBIC transceiver

Operational Shows if the port is functioning or not.

Link Indicates if the port has a valid connection to an external device.

FlowControl InUse Shows the flow control type in use. Flow control can eliminate

frame loss by “blocking” traffic from end stations connected

directly to the switch. Back pressure is used for half duplex and

IEEE 802.3x for full duplex. Note that flow control should not be

used if a port is connected to a hub.

Speed and Duplex

InUse

Displays the current port speed and duplex mode used.