Specifications

9033820-03 VH-2402S2 User Interface 17

IP Configuration

Use the IP Configuration screen to set the bootup option, or configure the

switch’s IP parameters. The screen shown below is described in the

following table.

Figure 2-9. IP Configuration

Vertical Horizon Stack Local Management

Network Configuration : IP Configuration : Unit: 1

Interface Type : Ethernet

IP Address : 10.1.0.1

Subnet Mask : 255.255.0.0

Gateway IP :

IP State : USER-CONFIG

Master IP : 10.1.0.1

Backup IP :

Use <TAB> or arrow keys to move, <Space> to scroll options.

Parameter Default Description

Interface Type Ethernet Indicates IP over Ethernet.

IP Address 10.1.0.1 IP address of the stack you are managing when

accessing the agent module over the network.

The agent module supports SNMP over UDP/IP

transport protocol. In this environment, all

systems on the Internet, such as network

interconnection devices and any PC accessing

the agent module (or running management

software) must have an IP address.

Valid IP addresses consist of four decimal

numbers, of 0 to 255, separated by periods.

Anything outside of this format will not be

accepted by the configuration program.

Subnet Mask 255.255.0.0 Subnet mask of the agent you have selected. This

mask identifies the host address bits used for

routing to specific subnets.

Default Gateway 0.0.0.0 Gateway used to pass trap messages from the

switch’s agent to the management station. Note

that the gateway must be defined if the

management station is located in a different IP

segment.