Specifications

16 VH-2402S2 User Interface VH-2402S2
Changing the Network Configuration
Use the Network Configuration menu to set the bootup option, configure
the switch’s Internet Protocol (IP) parameters, enable the on-board Web
agent, or to set the number of concurrent Telnet sessions allowed. The
screen shown below is described in the following table.
Figure 2-8. Network Configuration
Vertical Horizon Stack Local Management
Network Configuration
IP Configuration ...
IP Connectivity Test(Ping) ...
HTTP Configuration ...
MAX Number of allowed Telnet sessions (1-4) : 4
Physical Address : 00-00-E8-1F-AA-55
<APPLY> <OK> <CANCEL>
Use <TAB> or arrow keys to move. <Enter> to select.
Parameter Description
IP Configuration Screen used to set the bootup option, or configure the switch’s IP
parameters.
IP Connectivity Test Screen used to test IP connectivity to a (Ping) specified device.
HTTP Configuration Screen used to enable the Web Agent.
MAX Number of
Allowed Telnet
Sessions
The maximum number of Telnet sessions allowed to
simultaneously access the agent module.
MAC Address Physical address of the agent module.