User guide

Radio and Antenna Configuration
4-18 Configuring the Enterasys Wireless Standalone 802.11n AP
ToconfigurethecommonpropertiessharedbybothoftheAP’sradios:
1. SelecttheCountry.
2. SelecttheAPEnvironment.
3. Selectthenameoftheactu
alantennaconnectedtotheAPfromeachAntennaTypedrop‐
downmenu(AP3640only).
Caution: Selecting the wrong antenna may cause permanent damage to the AP.
Left Antenna Type (AP3640 only) Select the external antenna connected to the Left Antenna input
from the drop-down menu. The default is No Antenna.
Caution: Se
lecting the wrong antenna may cause permanent
damage to the AP.
Note: Th
e antenna and country selected determines the available
channel list and the maximum transmitting power for the country
selected.
Note: Cha
nging this setting will cause the AP to reboot.
Middle Antenna Type (AP3640
only)
Select the external antenna connected to the MIddle Antenna
input from the drop-down menu. The default is No Antenna.
Caution: Se
lecting the wrong antenna may cause permanent
damage to the AP.
Note: Th
e antenna and country selected determines the available
channel list and the maximum transmitting power for the country
selected.
Note: Cha
nging this setting will cause the AP to reboot.
Right Antenna Type (AP3640 only) Select the external antenna connected to the Right Antenna input
from the drop-down menu. The default is No Antenna.
Caution: Se
lecting the wrong antenna may cause permanent
damage to the AP.
Note: Th
e antenna and country selected determines the available
channel list and the maximum transmitting power for the country
selected.
Note: Cha
nging this setting will cause the AP to reboot.
Use Broadcast for Disconnection Select this checkbox to enable broadcast dissociation. When
enabled, the AP triggers clients to roam to other APs offering the
same services when:
• The AP’s WLAN services or radios are re-configured
• The AP is rebooted
• A radar event triggers automatic channel selection
Broadcast dissociation is disabled by default.
Function Buttons
Save Click to save your changes.
Undo Click to display the most recently saved values for the settings on
this screen.
Factory Defaults Click to display the fa
ctory defaults on this screen.The factory
defaults are not applied until you click Save.
Field Description