User guide

Field Description
Service Name Enter the name of the WLAN service. You can change this field
only if you are adding a new WLAN service. The default service
name is newService00.
SSID Enter the SSID of the WLAN service. The software automatically
p
opulates the SSID field with the default service name.
Enable This Service on Radio 1
(a/n)
Select to enable/deselect to disable the WLAN service on Radio 1.
The WLAN service is enabled on Radio 1 by default.
Enable This Service on Radio 2
(b/g/n)
Select to enable/deselect to disable the WLAN service on Radio 2.
T
he WLAN service is enabled on Radio 2 by default.
Default Policy Select a policy as the default for this WLAN service.
Advanced Settings
Suppress SSID Select to prevent/deselect to allow this SSID from appearing in the
beacon message sent by the AP. The wireless device user
se
eking network access will not see this SSID as an available
choice, and will need to specify it. SSIDs are allowed by default.
Enable 11h Support Select to enable/deselect to disable TPC (Transmission Power
C
ontrol) reports. By default this option is disabled. It is
recommended to enable this option. 11h support is disabled by
default.
Apply Power Reduction to 11h
Clien
ts
Select to enable/deselect to disable the AP to use reduced power
(as does the 11h client). By default this option is disabled. It is
recommended to enable this option. Power reduction to 11h
clients is disabled by default.
Process Client IE Requests Select to enable/deselect to disable the AP to accept IE requests
se
nt by clients via Probe Request frames and responds by
including the requested IE’s in the corresponding Probe Response
frames. By default this option is disabled. It is recommended to
enable this option.
Function Buttons
Save Click to save your changes.
Delete Click to delete the WLAN service.
Undo Click to display the most recently saved values for the settings on
this screen.
Factory Defaults Click to display the fa
ctory defaults on this screen.The factory
defaults are not applied until you click Save.
Creating a WLAN Service
3-18 Getting Started with your Enterasys Wireless Standalone 802.11n AP
ToconfiguretheGeneralpropertiesofaWLANservice:
1. (Optional)ChangetheServiceName.
2. (Optional)ChangetheSSI
Dorleavethedefault.
3. Selectatleastoneradiotoenablethi
sserviceon.
4. SelecttheDe
faultPolicy.
5. ClickSa
vetosaveyourchanges.