User guide

Configuring the Standalone AP for the First Time
Enterasys Wireless Standalone 802.11n AP User Guide 3-15
ToconfiguretheIPaddresssettings:
1. LocatethesettingsintheManagementsectionofthepage.
2. (Optional)DeselecttheDynamicIP(DHCP)checkboxtoconfigureastaticIPaddress.
3. ChangetheIPAddress.
4. (Optional)ChangetheSubnetMask.
5. (Optional)ChangetheGateway.
6. ClickSavetosaveyourchanges.
LED
LED Mode Select the LED Mode from the drop-down menu. You can select
one of the following modes:
• Off — Only displays LED fault patterns. LEDs are off when the
AP is fault free and initialization is finished.
• Normal — (default) LEDs function normally.
• Identify — All LEDs blink simultaneously.
• WDS Signal Strength — LEDs are used to indicate the WDS
signal strength as a bar-graph (VU-meter). Use this setting
only if the AP participates in a WDS.
• For more information about the different LED modes, see “LED
Behavior” on page A-5.
Network Time Protocol (NTP)
NTP Server Address Enter the IP address of the NTP Server. If you do not identify an
NTP server, the logs timestamp displays “uptime” for the AP.
Function Buttons
Save Click to save your changes.
Undo Click to display the most recently saved values for the settings on
this screen.
Factory Defaults Click to display the factory defaults on this screen.The factory
defaults are not applied until you click Save.
Field Description