User guide

SNMP MIBs
B-2 SNMP Traps and MIBs
SNMP MIBs
MIB-II (RFC1213)
Field Range Description
sysDescr Read-only printable char Contact/description field
sysObjectID Read-only OID The vendor’s authorative id
entification of the
network management subsystem contained in the
entity. This gives a value of
“1.3.6.1.4.1.4329.15.1.2.9" for AP3630 and
“1.3.6.1.4.1.4329.15.1.2.10" for AP3640.
sysUpTime Read-only TimeTics The AP uptime (in hundredths of a second)
sysContact Read-only printable char Contact/description field
sysName Read-only AP name
sysLocation Not supported
sysServices Bit Mask Hard coded string “Wireless Access Point”
Policy MIB
Field Range Description
etsysPolicyProfileMaxEntries Read-only Integer Max number of policy profiles supported
etsysPolicyProfileNumEntries Read-only Integer Current number of entries in the
etsysPolicyProfileTable
etsysPolicyProfileLastChange TimeTics sysUpTime which
et
sysPolicyProfileTable was last
modified
etsysPolicyProfileTableNextAvailableIndex Read-only Integer Next empty slot in the table
etsysPolicyProfileName Read-write 0-255
pr
intable char
policy name
etsysPolicyProfileRowStatus SNMP row status User can only set to the following SNMP
st
atus:
• active
• CreateAndGo
• CreateAndWait
•destroy
Note: Fo
r simplicity, the AP doesn’t
support notInService, which means the
row exists but wlanService cannot refer
to it.
etsysPolicyProfilePortVidStatus EnabledStatus • Enable-vlan tag will apply
• Disable - no vlan tag