Specifications

ManualsBrandsEnterasys ManualsComputer equipment8000/8600

Installing the Hardware

76 Enterasys X-Pedition 8000/8600 Getting Started Guide

SSR-SERC-04-AA E8.3.0.0

CLI Setup

Enter the following command at the CLI before

implementing any configurations.

1. Type the following from Enable mode to enter

Configuration mode

Enable -> Configure #

2. You may now begin configuring ports on the

SSR-SERC-04-AA. Refer to the Enterasys

X-Pedition Command Line Interface Reference

Manual for details.

Proper Boot Sequence

• Firmware loads.

• The control module for the chassis should indicate

that the SSR-SERC-04-AA was detected and is

operating correctly.

• The Online LED will turn on and remain lit (no other

LEDs should illuminate during module power-up).

Common Errors

• The ER16-SERC-04-AA is not inserted properly or

seated completely in the chassis

• Connectors for the connected lines are not seated

properly.

Helpful CLI Commands for Debugging

• System show hardware

• System show version

• Port show port status se.x.y (where x is the chassis

slot that contains the line card and y is a specific port

number on the card).

• System show bootlog

SSR-SERCE-04-AA

E8.3.0.0