Specifications

Enterasys Xpedition 8000/8600 Getting Started Guide 43
Hardware Overview
Cabling and Connector Specifications
The following table lists the media specifications for the Quad Serial – C/CE line cards.
LEDs
The Quad Serial – C/CE line cards use the following LEDs.
Port Type Specification
Dual serial • V.35, X.21, EIA530, EIA530A, or RS449
• LFH-60 high density connector; see Quad Serial – C and Quad
Serial – CE Line Cards on page 72 for pin assignments
• Recommended 3 meters (10 feet) segment length for standard
WAN line card-to-CSU/DSU data port.
1
1. Connector cables for WAN line cards may be ordered from Enterasys Networks. For detailed
information, including part numbers, see Quad Serial – C and Quad Serial – CE Line Cards on page 72.
LED Description
Offline When lit, this amber LED on the left side of the line card indicates
that the line card is offline (powered off) but is ready for hot swap.
The Offline LED also is lit briefly during a reboot or reset of the XP
but goes out as soon as the control module discovers the line card.
Online When lit, this green LED indicates that the line card is online and is
ready to receive, process, and send packets if configured to do so.
Per-port Link Indicates that the line card detects a cable plugged into the port and
a good link is established.
Per-port Rx Indicates when the port’s transceiver receives data.
Per-port Tx Indicates when the port’s transceiver transmits data.