Specifications

Enterasys Xpedition 8000/8600 Getting Started Guide 17
Hardware Overview
The XP-8600 DC power supply has a five-terminal wiring block on the front panel,
consisting of two positive (+) terminal, two negative (-) terminal and a safety ground. The
DC supply is designed to be powered by a 48-Volt DC source.
DC Power Supply Specifications
The following table lists the physical specifications for the XP’s DC Power Supplies.
The following table lists the environmental specifications for the XP’s DC Power Supplies
Switching Fabric Module (XP-8600 only)
On the XP-8600, the switching fabric is contained on a separate plug-in module. The XP-
8600 has slots for two of these modules. When two switching fabric modules are installed,
the module in the slot labelled “Fabric 1” serves as the primary switching fabric module,
and the module in the slot labelled “Fabric 2” serves as a redundant switching fabric
module.
Figure 8 shows the front panel of the XP-8600 Switching Fabric module.
Figure 8. Front panel of XP-8600 Switching Fabric module
XP-8000 XP-8600
Dimensions 11.00" (L) x 7.70" (W) x 2.55" (H) 12.15" (L) x 7.70" (W) x 5.05" (H)
Weight 6.5 lbs. (2.95 kg) 12.0 lbs. (5.45 kg)
Power Output 300 W 600 W
Voltage Range 36 to 72 V, 14 A @ 48 V nominal 36 to 72 V, 27 A @ 48 V nominal
Operating Temperature +5 to +40 °C (41 to 104 °F)
Non-operating
temperature
-30 to +73 °C (-22 to 164 °F)
Operating Humidity 15 to 90% (non-condensing)
G86-SWF
Switching Fabric
Active
Online
Swap
Hot
Offline