Specifications

Hardware Overview
16 Enterasys Xpedition 8000/8600 Getting Started Guide
DC Power Supply
The XP DC power supply delivers 3.3, 5, and 12 volts DC to the XP’s control module(s),
fan modules, and other components. A single DC power supply provides enough current
to operate a fully configured chassis.
Figure 6 shows the front view of an XP-8000 DC power supply.
Figure 6. Front view of an XP-8000 DC power supply
The XP-8000 DC power supply has a three-terminal wiring block on the front panel,
consisting of a positive (+) terminal, negative (-) terminal and a safety ground. The DC
supply is designed to be powered by a 48 Volt DC source. You should use 12- to 14-gauge
wire to connect the 48-Volt source to the XP-8600 DC power supply. You should use 12- to
14-gauge wire for the safety ground.
Figure 7 shows the front view of an XP-8600 DC Power Supply.
Figure 7. Front view of an XP-8600 DC power supply
G80-PDC
PWR
SN
!
To be installed in a restricted
access area in accordance
with the NEC or authority
having jurisdiction.
See manual for installation
instructions.
48/60V
14A MAX
PWR
G86-PDC
SN
48/60V
27A MAX
!
To be installed in a restricted
access area in accordance
with the NEC or authority
having jurisdiction.
See manual for installation
instructions.