Specifications

Setting Up Passwords
86 Enterasys Xpedition 8000/8600 Getting Started Guide
7. After verifying the SNMP configuration, save the changes to the Startup
configuration file by entering the following command:
Remember to answer “yes” when the CLI asks you whether you want to overwrite the
Startup configuration.
Setting Up Passwords
You can password-protect CLI access to the XP by setting up passwords for login access
and Enable mode access. Users who have a login password but not an Enable password
can use only the commands available in User mode. Users with an Enable password can
use commands available in the Enable and Configure modes as well as the commands in
User mode.
In addition, you can set up the XP for TACACS, TACACS+, and/or RADIUS
authentication on login and password by a TACACS or RADIUS server. Procedures for
configuring the XP for TACACS and RADIUS can be found in the The TeraLink 2000 Series
Library: User Reference.
Note: If a password is configured for Enable mode, the XP prompts for the password
when you enter the enable command. Otherwise, the XP displays a message
advising you to configure an Enable password, then enters Enable mode. From
Enable mode, you can access Configure mode to make configuration changes.
Community Table:
Index Community String Privilege
1. public READ-WRITE
SNMP statistics:
247019 packets received
246346 get requests
745 get-next requests
184 get-bulk requests
50 set requests
0 bad SNMP versions
1 bad community names
0 ASN.1 parse errors
0 PDUs too big
247018 packets sent
246346 get responses
745 get-next responses
184 get-bulk responses
50 set responses
copy active to startup