Datasheet

Memory Locations and Replacement Procedures
B-8 Mode Switch Bank Settings and Optional Installations
Installing the DRAM SIMM
To install a DRAM SIMM, refer to Figure B-7 and proceed as follows:
1. Insert the DRAM SIMM down between the connector fingers.
2. Pivot the DRAM SIMM downward so the tabs on the connector arms align with the
two DRAM SIMM alignment notches. With the two connector arms spread outward,
push the DRAM SIMM down between the connector arms. Then release the two
connector arms to lock the DRAM SIMM into place.
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Figure B-7 Installing the DRAM SIMM
1 DRAM SIMM 3 Connector arms
2 Connector fingers 4 SIMM alignment notches (2)
Â
Â
À
Ã
Ã
Á