Datasheet

Memory Locations and Replacement Procedures

B-6 Mode Switch Bank Settings and Optional Installations

Installing the DIMM

To install the memory module, refer to Figure B-5 and proceed as follows:

1. With the connector arms set in the open position, insert the DIMM between the

connector fingers and push the DIMM into the connector until the tabs on the two

connector arms pull in towards the DIMM alignment notches.

2. Push the DIMM further into the connector until the two DIMM alignment notches

and the tabs on the two connector arms lock the DIMM into place.

Caution: Observe all antistatic precautions when handling sensitive electronic equipment.

Figure B-5 Installing the DIMM on 7H4382-25

1 Connector arms 3 Connector fingers

2 DIMM memory module 4 DIMM alignment notches (2)