Datasheet

Completing the Installation

3-30 Installation

Completing the Installation

Completing the DFE-Platinum module installation depends on if the module is being

installed in:

• a new DFE-Platinum module system (refer to “Completing the Installation” on

page 3-30), or

• an established, operating DFE-Platinum module system (refer to “Completing the

Installation of a DFE-Platinum Module in an Existing System” on page 3-32).

Completing the Installation of a New System

In a new system of DFE-Platinum modules, one of the installed DFE-Platinum modules

will become the management module on chassis power up, and all DFE-Platinum

modules will automatically be set to the factory default values. A complete list of the

factory default values are provided in Chapter 3 of the Matrix DFE-Platinum Series

Configuration Guide.

Modem Port Adapter Wiring and Signal Diagram

RJ45 DB25

Pin Conductor Pin Signal

1 Blue 2 Transmit (TX)

2 Orange 8 Data Carrier Detect (DCD)

4 Red 3 Receive

5 Green 7 Ground (GRD)

6 Yellow 20 Data Terminal Ready (DTR)

8 Gray 22 Ring Indicator

RJ45 Connector (Female)

Pins

DB25 Connector (Male)

131

Pins

14 25