Datasheet
Installing Module into Matrix N3 Chassis
Matrix DFE-Series Module Installation Guide 3-15
Installing Module into Matrix N3 Chassis
To install a DFE-Platinum module into the Matrix N3 chassis, refer to Figure 3-7 and use
the installation procedure described in “Installing Module into SmartSwitch 6000,
Matrix E7 or Matrix N7 Chassis” on page 3-12.
A DFE-Platinum module can be installed
in any available chassis slot (1 through 3).
Caution: Failure to observe static safety precautions could cause damage to the
DFE-Platinum module. Follow static safety handling rules and wear the antistatic wrist
strap.
Do not cut the non-conductive bag to remove the DFE-Platinum module. Sharp objects
contacting the board or components can cause damage.
Caution: When setting the locking levers to the closed position, do not try to force the
locking levers to the point that they touch the face of the front panel. Forcing the locking
levers to this point could damage the module and chassis.
Figure 3-7 Installing Module into Matrix N3 Chassis
1 Card guides 5 Upper locking tab (shown in closed position)
2 Slot 1 (Top slot is slot 3.) 6 Lower locking tab (shown in closed position)
3 Module card 7 FTM2 backplane connectors
4 Metal back panel
7C203-1
REDUNDANCY
PWR
100-125V~12.0A
200-240V~6.0A
50/60 Hz
7C203-1
REDUNDANCY
PWR
100-125V~12.0A
200-240V~6.0A
50/60 Hz
1X
G
R
O
U
P
1
G
R
O
U
P
2
11X
13X
23X
OFFLINE/
RESET
COM
CPU
MGMT
GROUP
SELECT
GROUP
1
2
1
2
3
4
5
6
7
8
9
10
11
12
DFE
7H4382-25
FAST ENET
Á
Æ
Ä
Å
Â
Ã
À