Datasheet

Installing an Optional Mini-GBIC
3-6 Installation
Installation
To install a Mini-GBIC with an MT-RJ connection, refer to Figure 3-3, or for a Mini-GBIC
with an LC connection, refer to Figure 3-4, and proceed as follows:
1. Hold the Mini-GBIC with its top side facing up and its 7-pin edge connector facing the
port slot.
2. Carefully align the Mini-GBIC with the port slot.
3. Push the Mini-GBIC into the port slot until the Mini-GBIC “clicks” and locks into
place.
Note: If the Mini-GBIC is one with an RJ45 connector (not shown), the installation
procedure is the same as described below. However, the Mini-GBIC has a wire handle to
release it.
Figure 3-3 Mini-GBIC with MT-RJ Connector
1 Mini-GBIC (MGBIC-MT01) 4 Port slot
2 Mini-GBIC
, top side 5 Mini-GBIC, protective dust cover
3 7-Pin edge connector (insertion side) 6 Release tab
1
2
3
4
5
6
1
2
3
4
5
6
Ã
Â
Å
À
Á
Ä