Datasheet

Installing Optional Ethernet Interface Module

3-4 Installation

4. Carefully align the two interface module connectors with the main board connectors.

Then press straight down over the two interface module connectors, applying

pressure until they are properly seated.

5. Use the two saved coverplate screws to fasten the interface module to the

DFE-Platinum module front panel. Do not tighten the two coverplate screws at this

time.

6. Use the screw removed from the main board and fasten the interface module to the

standoff. Tighten the screw.

7. Tighten the two coverplate screws.

8. This completes the interface module installation. To install Mini-GBICs into the

interface module, proceed to “Installing an Optional Mini-GBIC” on page 3-5.

Otherwise, proceed to “Backplane Connections and Installation Rules” on page 3-8 to

install the module into the chassis.

Figure 3-2 Installing the Ethernet Interface Module

1 Screw (1) 4 Standoff 7 Interface module connectors

2 Screw hole 5 Optional interface module 8 Main board connectors

3 Main board 6 DFE-Platinum module

front panel 9 Coverplate screws (2)

11X

13X

23X

OFFLINE/

RESET

COM

CPU

OUP

SELECT

OUP

ST EN

DFE