Datasheet

Matrix DFE-Series Module Installation Guide 3-1
3
Installation
This chapter provides the instructions to install the 7H4382-25 DFE-Platinum module and
optional interface module 7G-6MGBIC.
A Phillips screwdriver is required to install an optional interface module into the
7H4382-25. Follow the order of the sections listed below to correctly install the module.
• “Unpacking the DFE-Platinum Module” on page 3-2
• “Installing Optional Ethernet Interface Module” on page 3-2
• “Installing an Optional Mini-GBIC” on page 3-5
• “Backplane Connections and Installation Rules” on page 3-8
• “Installing Module into SmartSwitch 6000, Matrix E7 or Matrix N7 Chassis” on
page 3-12
• “Installing Module into Matrix N3 Chassis” on page 3-15
• “Connecting to the Network” on page 3-16
• “Connecting to COM Port for Local Management” on page 3-23
• “Completing the Installation” on page 3-30
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the DFE-Platinum module to check for any exceptions to the
supported features and operation documented in this guide.