Installation guide

Installation 3-1

Installation

This chapter provides the instructions to install the 6H352-25 module. A Phillips screwdriver is

required to install options into the module. Follow the order of the sections listed below to

correctly install the module.

• Unpacking the 6H352-25 (Section 3.1)

• Installing Optional HSIMs, VHSIMs or Memory Upgrade (Section 3.2)

• Installing the 6H352-25 into the MATRIX E7 Chassis (Section 3.3)

• Installing the 6H352-25 into the SmartSwitch 6000 Chassis (Section 3.4)

• Connecting to the Network (Section 3.5)

• Completing the Installation (Section 3.6)

ELECTRICAL HAZARD: Only qualified personnel should install the 6H352-25.

NOTE: Read the Release Notes shipped with the module to check for any exceptions to

the supported features and operation documented in this guide.