User`s guide

Installation

This chapter provides the instructions to install the 6H302-48 or 6H303-48 module. A Phillips

screwdriver is required to install options into the module. Follow the order of the sections listed

below to correctly install the module.

• Unpacking the Module (Section 3.1)

• Installing Options (Section 3.2)

• Installing the Module into the Matrix E7 Chassis (Section 3.3)

• Installing the Module into the SmartSwitch 6000 (6C105) Chassis (Section 3.4)

• Connecting to the Network (Section 3.5)

• Completing the Installation (Section 3.6)

ELECTRICAL HAZARD: Only qualified personnel should install the module.

NOTE: Read the Release Notes shipped with the module to check for any exceptions to

the supported features and operation documented in this guide.