Specifications

SPECTRUM Software Release Notice (SSRN)
For SPECTRUM 6.6 with Service Pack 5 CD release
Page 53
Document 5156
2 You can create SmartSwitch 9000
models in Location or Organization views
even though a Contains relation cannot
be established with the SmartSwitch
chassis model and the models do not
show up in the Device view of the
SmartSwitch.
Do not create SmartSwitch 9000 models
in the Location or Organization views.
Instead, create them in the Topology
view and then copy the Device icon from
the Universe Topology view into the
Location view. The SmartSwitch chassis
model has a Container view that contains
Location view icons for all modeled
SmartSwitch modules. This ensures that
the proper relationship exists between
the models.
3 When a 9A6x6 is modeled as a
standalone device, the Chassis Device
view incorrectly displays the backplane
interfaces.
This is a firmware issue. Upgrade to
firmware 3.00.04 or later.
4 The graph in the ATM Performance view
may seem to display information
incorrectly. For example, the Log and Lin
(Linear) graphs may appear to show
100% of capacity when the cell rate
exceeds a certain value.
This happens when the graph is used to
show both percentages and rates, and
has a limitation on the total cell rate the
graph can show. Percentages cannot
exceed 100% and the rates have a
multiplier associated with them (noted
by an asterisk next to the attribute).
When the cell rate exceeds the graph’s
ability to show actual values, the % line
appears flat on the graph. The actual
tick-for-tick value of the rate is shown in
the table beside the graph.
5 The 9H531-18 devices running firmware
01.07.11 model as 9H532_18 models.
The 9H531-18 and 9H532-18 devices
use the same sysObjectID attribute. This
is a firmware issue.
Known Anomalies: SmartSwitch 9000/9500
Item Description Solution