Specifications

SPECTRUM Software Release Notice (SSRN)
For SPECTRUM 6.6 with Service Pack 5 CD release
Page 26
Document 5156
Element MIB (FCFABRIC-ELEMENT- MIB), and version 4.0 of the
Enterprise Switch MIB (SW- MIB). Five new traps, introduced with
FCMGMT_MIB, are now mapped.
• The Motorola Vanguard management module has been updated to
include management of the Vanguard 6435 and 6455 devices.
Additional enhancements include: comprehensive physical interface
modeling; full trap support; and Frame Relay Manager integration.
Non-Persistent Connection Manager (NPC)
• Support for Multilink PPP has been added by allowing a Dialup_Link
model to be pasted on more than one interface on a single device
model. When the Dialup_Link model is pasted on each of the PPP
interfaces which make up the multilink, these interfaces will form a
secondary group. A new Dialup_Link model attribute,
DevSecGrpActiveCriteria, controls the method used to determine the
state of a secondary group, and thus the secondary link. This attribute
can be set from the Dialup_Link 'Information' GIB view to the following
values: “Any Secondary IF Active” - If any member of the secondary
group is active, then the multilink is active; “All Secondary IFs Active” -
If all members of the secondary group are active, then the multilink is
active.
• Support for Dialer Profile configurations has been added by allowing
Dialup_Link models to be pasted on the Dialer interfaces. These logical
interfaces represent a call to or from a particular peer. At call time, a
Dialer interface will dynamically bind to a physical interface which is
selected from a Dialer pool. Specialized intelligence was implemented
to infer the operational state of Dialer interfaces from its ifAdmin/ifOper
values as well as the state of any physical interfaces it may be bound
to.
Process Daemon
• Processed now runs as a Windows service, which lets SPECTRUM
continue to run on a Windows machine even if the Windows user logs
off the machine. When installing SPECTRUM in the Windows
environment, you will be prompted to enter a username and password
in the Windows Service Configuration dialog box. This username and
password can be either a local machine account or a domain account