User`s guide

Configuring Static Unicast Addresses
Device Control Menu Screens 7-35
Status The status for an entry can be set to:
Permanent–This entry is currently in use and will remain so
after the next reset of the switch.
DeleteOnReset–This entry is currently in use and will
remain so until the next reset.
Lock Port–Enables the port locking mode. For details, refer
to Section 10.15.1.
Unlock Port–Disables the port locking mode. For details,
refer to Section 10.15.2.
Invalid–Removes the corresponding entry.
DeleteOnTimeOut–This entry is currently in use and will
remain so until it is aged out. (Refer to Aging Time in
Section 8.4.)
Other–This entry is currently in use, but the conditions
under which it will remain, differ from the preceding values.
[Show] Displays the static address table sorted on VID as the
primary key and MAC address as secondary key.
[More] Scrolls through entries in the static address table.
[Set] Adds the specified entry to the static address table, such as
shown in the following example:
VID: 1 MAC: 00-00-00-e8-34-22
Unit: 1 Port: 1
Status: Permanent
Parameter Description