Installation guide

Using LANVIEW
4-2
Fast Ethernet Speed LED
This LED indicates whether the port is in 10 Mbps or 100 Mbps Ethernet. When the LED is off,
the port is functioning at 10 Mbps. When the LED is on solid green, the speed is 100 Mbps.
Figure 4-1 LANVIEW LEDs (both modules)
Table 4-1 describes the LED indications and provides recommended actions as appropriate. If the
recommended actions suggest contacting Enterasys Networks for technical support, refer to
“Getting Help” in About This Guide for directions.
➀
Port 1, Group 1 LEDs
NOTE: The terms flashing, blinking, and solid used in Tabl e 4 -1 indicate the following:
Flashing indicates an LED is flashing randomly.
Blinking indicates an LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid indicates a steady LED light. No pulsing.
36771_09
GROUP
GROUP
SELECT
À
RX TX
GROUP
SELECT
RESET
COM
CPU
11X
1X
G
R
O
U
P
1
FAST ENET
5H153-50
GROUP
1
2
3
4
5
6
7
8
9
10
11
12
1
2
3
4