Installation guide

3-1

Installation

This chapter provides the instructions to install the 5H152-50 and 5H153-50 modules and optional

5PIM-02 and 5PIM-G06 port interface modules. The installation procedures for installing optional

GPIMs in the 5PIM-G06 are also provided.

A Phillips screwdriver is required to install options into the module. Follow the order of the

sections listed below to correctly install the module.

• Unpacking the Module (Section 3.1)

• Installing Optional 5PIMs (Section 3.2)

• Installing Optional GPIMs (Section 3.3)

• Installing the Module into the 5C105 MATRIX E5 Chassis (Section 3.4)

• Connecting to the Network (Section 3.5)

• Connecting Fiber Optic Cables to GPIMs (Section 3.6)

• Completing the Installation (Section 3.7)

ELECTRICAL HAZARD: Only qualified personnel should install the module.

NOTE: Read the Release Notes shipped with the module to check for any exceptions to

the supported features and operation documented in this guide.