Installation guide

Completing the Installation
3-18 Installation
To remove the SC connector from the GPIM, carefully pull the connector out of the port. It may
need to be wiggled gently to release the latching keys.
Figure 3-13 Fiber Port LED Designations
If a link has not been established, refer to Chapter 4 for LED troubleshooting details. Refer to
“Getting Help” in About This Guide for details on contacting Enterasys Networks if a problem
persists.
3.7 COMPLETING THE INSTALLATION
After installing the module and making the connections to the network, proceed as follows:
1. If the chassis is installed in a rack that has strain-relief brackets, secure the cables by running the
cables along the strain-relief bracket and tying them to the bracket using cable ties.
2. The module is now ready to be configured through Local Management. Refer to the MATRIX E5
Series Modules Local Management User’s Guide for information on how to access and use
Local Management. For details on how to view the user’s guide on the web or to order printed
copies of this or other manuals, refer to the “Related Documents” section in About This Guide.
1
2
Receive (RX)
Transmit (TX)
Receive (RX)
Transmit (TX)
2549_02