Specifications

64 Enterasys Xpedition 2000 Getting Started Guide
You are unable to access the
configuration commands in the CLI.
From the CLI, type enable to access Enable
mode, then type configure to access
Configure mode.
Configuration changes do not seem to
be taking effect.
Use the procedure in Activating the
Configuration Commands in the Scratchpad on
page 60 to activate the changes.
Configuration changes are not
reinstated after a reboot.
Use the procedure in Saving the Active
Configuration to the Startup Configuration File
on page 60 to save the configuration changes
to the Startup configuration file.
The XP-2000 is not resolving DNS
names.
Use the procedure in Setting the DNS Domain
Name and Address on page 52 to set up DNS.
If you have already performed this procedure,
make sure you can use NS lookup on the DNS
server to get the default domain.
An SNMP manager cannot access the
XP-2000.
Use the procedure in Setting Up SNMP
Community Strings on page 48 to set up an
SNMP community string and specify a target
for SNMP traps.
If you have already performed this procedure,
type snmp show all in the CLI to check the
SNMP settings.
Use the traceroute and ping commands to
verify that the XP-2000 can reach the SNMP
management station.
You are unable to ping a certain host. Create and add an IP or IPX interface for the
host. See the The TeraLink 2000 Series Library:
User Reference for information.
If you experience this difficulty Try this remedy