Specifications
Loading System Image Software
56 Enterasys Xpedition 2000 Getting Started Guide
6. Enter the show command to show the commands you just entered. Because you have
not activated these configuration changes yet, they are listed in the scratchpad section
of the output. Here is an example:
Note: The other configuration changes made during this CLI session are also listed.
Active changes are listed in the “Running system configuration section” and
unactivated changes are listed in the “Non-committed changes in
Scratchpad” section.
7. To activate the SYSLOG commands, enter the save active command.
Loading System Image Software
The XP-2000 operates using the system image software installed in its internal flash chip.
To upgrade the system software and operate using the upgraded image, go through the
following procedure:
1. Display the current boot settings by entering the system show version command, as
shown in the following example:
Note: In this example, the location “pc-flash” indicates that the XP-2000 is set to use
the factory-installed system software in the motherboard’s internal flash chip.
ssr-1(config)# show
Running system configuration:
!
! Last modified from Console on Mon May 14 12:37:21 2001
!
1 : interface add ip en0 address-netmask 10.50.11.22/16
!
2 : system set dns server 10.50.11.12
3 : system set dns domain mktg.company.com
4 : system set name "xp-1"
5 : system set location "Sunnyvale, CA
6 : system set contact "John Smith"
7 : system set hashed-password login jNIssH c976b667e681d03ccd5fc527f219351a
8 : system set hashed-password enable zcGzbO 5d1f73d2d478ceaa062a0b5e0168f46a
!
9 : snmp set community public privilege read
10 : snmp set target 10.50.11.12 community public
******** Non-committed changes in Scratchpad ********
1*: system set syslog server 10.50.11.12
2*: system set syslog level info
3*: system set syslog facility local0
ssr-1# system show version
Software Information
Software Version : 4.0.0.0
Copyright : Copyright (c) 2001 Enterasys Networks
Image Information : Version 0.0.0.0, built on Mon May 14 01:16:15 2001
Image Boot Location: tftp://10.50.89.88/xp1200
Boot Prom Version : prom-1.1.0.0