Specifications

Enterasys Xpedition 2000 Getting Started Guide 49
Setting Up SNMP Community Strings
2. Ensure that you are in Configure mode by entering the configure command in the
CLI.
3. Use the following commands to add an SNMP community string and set a target for
the traps.
Note: The target IP address must be locally attached to the XP-2000. You cannot
specify a target that is connected to the XP-2000 by another router. If the IP
address is more than one hop away from the XP-2000, configure the
XP-2000 with a static route to the target so that a cold start trap is sent.
4. Enter the show command to examine the changes accumulated in the scratchpad.
5. Enter the save active command to activate the commands you entered in the previous
steps.
6. To verify the changes, enter the snmp show all command.
snmp set community <community-name> privilege read
snmp set target
<IP-addr> community <community-name>