Specifications

Enterasys Xpedition 2000 Getting Started Guide 31
Installing the Hardware
Figure 15. Installing a 1000BASE-SX or 1000BASE-LX gigabit expansion module
9. Replace the XP-2000’s cover.
When you are ready to attach the segment cables, use the procedures in Attaching Port
Cables on page 34.
Attaching the Console Management Cables
The XP-2000 has two ports for attaching management consoles to the XP-2000.
• A male DB-9 DCE port for direct serial connection from a terminal. Use this port to
perform basic setup, including setting up the XP-2000 for management through the
network using the CLI or SNMP.
• An RJ-45 10/100Base-T DTE port for Telnet connection from a host on the network. The
port is configured for Media Data Interface (MDI). You use this port to manage the XP-
2000 using the CLI or SNMP.
Connecting to the Serial Port
Figure 16 shows where to plug in the cable to the XP-2000’s serial port. The procedure
following the figure describes how to set up and insert the cable.
21
87654321 87654321
1000BASE-SX
87654321
10/100BASE-TX
1
3
2
4
CONSOLE
10/100 MGMT
OK
ERR DIAG
HBT
G2M-HTXA2-08 G2M-GSXA1-02
10/100BASE-TX 10/100BASE-TX
Tx
Rx AN
LinkTx
Rx AN
Link
8
9
7
RST
SYS
*
*
*
These two screws are
used only with extended
EMI face plate