Specifications

Installing the Hardware
30 Enterasys Xpedition 2000 Getting Started Guide
Figure 14. Installing the EMI extended face plate (view from inside chassis)
6. Insert the 1000BASE-SX or 1000BASE-LX gigabit expansion module from the top and
ensure that it makes maximum surface contact with its face plate.
7. Line up the two screw holes at the back of the expansion module and connect
the stacking connector at the back of the expansion module to the pins on the
XP-2000’s motherboard.
Caution: The female and male connectors for the expansion modules are not keyed, so it is
possible to misalign the connection. Ensure that all pins fit properly into the female
connector on the expansion module before applying power to the XP-2000.
8. Use the phillips-head screwdriver to tighten all six screws that will hold the
expansion module in place in the XP-2000’s chassis.
Note: There are two additional screws that are required with the EMI extended face
plate as shown below:
Front of XP-2000
Align Slots Over
Stand-offs on
Mother Board.
Additional
Screw Hole
on Face Plate