Specifications

Hardware Overview
8 Enterasys Xpedition 2000 Getting Started Guide
• SNMP MIBs and traps – The XP-2000 supports SNMP v1 and many standard
networking MIBs. You can access the XP-2000’s SNMP agent using Enterasys
integration software for HP OpenView 5.x on Windows NT or Solaris 2.x, or Enterasys
Spectrum on Solaris 2.x. Chapter 3, Software Installation and Setup, in this guide explains
how to set up SNMP on the XP-2000.
Hardware Overview
This section describes the XP-2000’s hardware specifications. Chapter 2, Hardware
Installation, in this guide describes how to install the hardware. This section describes the
following hardware:
• Chassis and external controls
• Motherboard features
• Power supplies
• Expansion modules
Chassis
The XP-2000 chassis contains 16 10/100BASE-TX ports and two expansion slots (slots 3
and 4). Currently, Enterasys configures the XP-2000 at the factory in one of the following
ways before shipping:
• 16 10/100BASE-TX ports and two empty expansion slots
• 24 10/100BASE-TX ports and a 2-port 1000BASE-SX or 1000BASE-LX gigabit module
in the expansion slot
Figure 1 shows the front view of a loaded XP-2000.
Figure 1. Front view of loaded XP-2000
21
87654321 87654321
1000BASE-SX
87654321
10/100BASE-TX
1
3
2
4
CONSOLE
10/100 MGMT
OK
ERR DIAG
HBT
RST
G2M-HTXA2-08 G2M-GSXA1-02
10/100BASE-TX 10/100BASE-TX
Tx
Rx
Link
AN
Tx
Rx
Link
AN
SYS
10/100BASE-TX module 1000BASE-SX (Gigabit) module